In seismology, surface rupture (or ground rupture, or ground displacement) is the visible offset of the ground surface when an earthquake rupture along a fault affects the Earth's surface. Surface rupture is opposed by buried rupture, where there is no displacement at ground level. This is a major risk to any structure that is built across a fault zone that may be active, in addition to any risk from ground shaking.[1] Surface rupture entails vertical or horizontal movement, on either side of a ruptured fault. Surface rupture can affect large areas of land.[2]
__TOC__
Not every earthquake results in surface rupture, particularly for smaller and deeper earthquakes.[1] In some cases, however, the lack of surface effects is because the fault that moved does not reach the surface. For example, the 1994 Northridge earthquake had a moment magnitude of 6.7, caused major damage in the Los Angeles area, occurred at 18.20NaN0 below the Earth's surface, but did not cause surface rupture, because it was a blind thrust earthquake.[3]
Surface ruptures commonly occur on pre-existing faults. Only rarely are earthquakes (and surface ruptures) associated with faulting on entirely new fault structures.[4] There is shallow hypocenter, and large fracture energy on the asperities,[5] the asperity shallower than 5km (03miles). Examples of such earthquakes are San Fernando earthquake, Tabas earthquake, and Chi-Chi earthquake.[6]
In surface rupture earthquakes, the large slips of land are concentrated in the shallow parts of the fault.[7] And, notably, permanent ground displacements which are measureable can be produced by shallow earthquakes, of magnitude M5 and greater.[8]
The form that surface rupturing takes depends on two things: the nature of the material at the surface and the type of fault movement.
Where there are thick superficial deposits overlying the trace of the faults, the resulting surface effects are typically more discontinuous. Where there is little or no superficial deposits, the surface rupture is generally continuous, except where the earthquake rupture affects more than one fault, which can lead to complex patterns of surface faulting, such as in the 1992 Landers earthquake.[9]
Surface ruptures associated with normal faults are typically simple fault scarps. Where there are significant superficial deposits, sections with more oblique faulting may form sets of en-echelon scarp segments. Antithetic faults may also develop, giving rise to surface grabens.
Reverse faulting (particularly thrust faulting) is associated with more complex surface rupture patterns since the protruding unsupported part of the hanging-wall of the fault is liable to collapse. In addition there may be surface folding and back-thrust development.
Strike-slip faults are associated with dominantly horizontal movement, leading to relatively simple linear zones of surface rupture where the fault is a simple planar structure. However, many strike-slip faults are formed of overlapping segments, leading to complex zones of normal or reverse faulting depending on the nature of the overlap. Additionally, where there are thick superficial deposits, the rupture typically appears as a set of en-echelon faults.[10]
To retrofit a house to survive surface rupture requires engineered design by geotechnical, and structural or civil engineers. This can be quite expensive.[4]