The Cavendish experiment, performed in 1797–1798 by English scientist Henry Cavendish, was the first experiment to measure the force of gravity between masses in the laboratory[1] and the first to yield accurate values for the gravitational constant.[2] [3] Because of the unit conventions then in use, the gravitational constant does not appear explicitly in Cavendish's work. Instead, the result was originally expressed as the relative density of Earth,[4] or equivalently the mass of Earth. His experiment gave the first accurate values for these geophysical constants.
The experiment was devised sometime before 1783 by geologist John Michell,[5] [6] who constructed a torsion balance apparatus for it. However, Michell died in 1793 without completing the work. After his death the apparatus passed to Francis John Hyde Wollaston and then to Cavendish, who rebuilt the apparatus but kept close to Michell's original plan. Cavendish then carried out a series of measurements with the equipment and reported his results in the Philosophical Transactions of the Royal Society in 1798.[7]
The apparatus consisted of a torsion balance made of a 6feet wooden rod horizontally suspended from a wire, with two 2adj=mid0adj=mid, 1.61lb lead spheres, one attached to each end. Two massive 12inches, 348lb lead balls, suspended separately, could be positioned away from or to either side of the smaller balls, away.[8] The experiment measured the faint gravitational attraction between the small and large balls, which deflected the torsion balance rod by about 0.16" (or only 0.03" with a stiffer suspending wire).
The two large balls could be positioned either away from or to either side of the torsion balance rod. Their mutual attraction to the small balls caused the arm to rotate, twisting the suspension wire. The arm rotated until it reached an angle where the twisting force of the wire balanced the combined gravitational force of attraction between the large and small lead spheres. By measuring the angle of the rod and knowing the twisting force (torque) of the wire for a given angle, Cavendish was able to determine the force between the pairs of masses. Since the gravitational force of the Earth on the small ball could be measured directly by weighing it, the ratio of the two forces allowed the relative density of the Earth to be calculated, using Newton's law of gravitation.
Cavendish found that the Earth's density was times that of water (although due to a simple arithmetic error, found in 1821 by Francis Baily, the erroneous value appears in his paper).[9] [10] The current accepted value is 5.514 g/cm3.
To find the wire's torsion coefficient, the torque exerted by the wire for a given angle of twist, Cavendish timed the natural oscillation period of the balance rod as it rotated slowly clockwise and counterclockwise against the twisting of the wire. For the first 3 experiments the period was about 15 minutes and for the next 14 experiments the period was half of that, about 7.5 minutes. The period changed because after the third experiment Cavendish put in a stiffer wire. The torsion coefficient could be calculated from this and the mass and dimensions of the balance. Actually, the rod was never at rest; Cavendish had to measure the deflection angle of the rod while it was oscillating.[11]
Cavendish's equipment was remarkably sensitive for its time.[9] The force involved in twisting the torsion balance was very small,,[12] (the weight of only 0.0177 milligrams) or about of the weight of the small balls.[13] To prevent air currents and temperature changes from interfering with the measurements, Cavendish placed the entire apparatus in a mahogany box about 1.98 meters wide, 1.27 meters tall, and 14 cm thick,http://cavendish-deneyi.com/pdf/Cavendish-c%CC%A7izim-03.pdf all in a closed shed on his estate. Through two holes in the walls of the shed, Cavendish used telescopes to observe the movement of the torsion balance's horizontal rod. The key observable was of course the deflection of the torsion balance rod, which Cavendish measured to be about 0.16" (or only 0.03" for the stiffer wire used mostly).[14] Cavendish was able to measure this small deflection to an accuracy of better than using vernier scales on the ends of the rod.[15] The accuracy of Cavendish's result was not exceeded until C. V. Boys' experiment in 1895. In time, Michell's torsion balance became the dominant technique for measuring the gravitational constant (G) and most contemporary measurements still use variations of it.[16]
Cavendish's result provided additional evidence for a planetary core made of metal, an idea first proposed by Charles Hutton based on his analysis of the 1774 Schiehallion experiment.[17] Cavendish's result of 5.4 g·cm-3, 23% bigger than Hutton's, is close to 80% of the density of liquid iron, and 80% higher than the density of the Earth's outer crust, suggesting the existence of a dense iron core.[18]
The formulation of Newtonian gravity in terms of a gravitational constant did not become standard until long after Cavendish's time. Indeed, one of the first references to G is in 1873, 75 years after Cavendish's work.[19]
Cavendish expressed his result in terms of the density of the Earth. He referred to his experiment in correspondence as 'weighing the world'. Later authors reformulated his results in modern terms.[20] [21] [22]
G=g
| |||||||
Mearth |
=
3g | |
4\piRearth\rhoearth |
G =,[23] which differs by only 1% from the 2014 CODATA value of .[24] Today, physicists often use units where the gravitational constant takes a different form. The Gaussian gravitational constant used in space dynamics is a defined constant and the Cavendish experiment can be considered as a measurement of this constant.In Cavendish's time, physicists used the same units for mass and weight, in effect taking g as a standard acceleration. Then, since R was known, ρ played the role of an inverse gravitational constant. The density of the Earth was hence a much sought-after quantity at the time, and there had been earlier attempts to measure it, such as the Schiehallion experiment in 1774.
The following is not the method Cavendish used, but describes how modern physicists would calculate the results from his experiment.[25] [26] [27] From Hooke's law, the torque on the torsion wire is proportional to the deflection angle
\theta
\kappa\theta
\kappa
\theta
\kappa\theta =LF
For F, Newton's law of universal gravitation is used to express the attractive force between a large and small ball:
F=
GmM | |
r2 |
Substituting F into the first equation above gives
\kappa\theta =L
GmM | |
r2 |
(1)
To find the torsion coefficient (
\kappa
T=2\pi\sqrt{
I | |
\kappa |
Assuming the mass of the torsion beam itself is negligible, the moment of inertia of the balance is just due to the small balls. Treating them as point masses, each at L/2 from the axis, gives:
I=m\left(
L | |
2 |
\right)2+m\left(
L | |
2 |
\right)2=2m\left(
L | |
2 |
\right)2=
mL2 | |
2 |
and so:
T=2\pi\sqrt{
mL2 | |
2\kappa |
Solving this for
\kappa
G=
2\pi2Lr2\theta | |
MT2 |
Once G has been found, the attraction of an object at the Earth's surface to the Earth itself can be used to calculate the Earth's mass and density:
mg=
GmM\rm | ||||||
|
M\rm=
| |||||||
G |
\rho\rm=
M\rm | |
\tfrac{4 |
{3}\pi
3} | |
R | |
\rmearth |
=
3g | |
4\piR\rmG |
Symbol | Unit | Definition | |
---|---|---|---|
\theta | radians | Deflection of torsion balance beam from its rest position | |
F | N | Gravitational force between masses M and m | |
G | m kg s | Gravitational constant | |
m | kg | Mass of small lead ball | |
M | kg | Mass of large lead ball | |
r | m | Distance between centers of large and small balls when balance is deflected | |
L | m | Length of torsion balance beam between centers of small balls | |
\kappa | N m rad | Torsion coefficient of suspending wire | |
kg m | Moment of inertia of torsion balance beam | ||
T | s | Period of oscillation of torsion balance | |
g | m s | Acceleration of gravity at the surface of the Earth | |
M | kg | Mass of the Earth | |
R | m | Radius of the Earth | |
\rho | kg m | Density of the Earth |