| South African Class NG G16A | |
| Hatnote: | No. NG141 - ♠ No. NG155 |
| Powertype: | Steam |
| Designer: | Alfred County Railway (Phil Girdlestone) |
| Builder: | Alfred County Railway |
| Serialnumber: | BP 7866, Hunslet-Taylor 3900 |
| Buildmodel: | Class NG G16A |
| Builddate: | 1989-1990 |
| Totalproduction: | 2 |
| Whytetype: | 2-6-2+2-6-2 (Double Prairie) |
| Uicclass: | 1'C1'+1'C1'h4t |
| Driver: | 3rd & 4th coupled axles |
| Gauge: | narrow |
| Leadingdiameter: | 210NaN0 |
| Coupleddiameter: | 330NaN0 |
| Trailingdiameter: | 210NaN0 |
| Minimumcurve: | 1600NaN0 |
| Wheelbase: | 43feet |
| Engine Total: | 13feet each |
| Coupled: | 6feet each |
| Pivotcentres: | 23feet |
| Over Couplers: | 48feet |
| Width: | 70NaN0 |
| Height: | 10feet |
| Frametype: | Bar |
| Axleload: | 6lt ♠ 6lt |
| Leadingbogie/Pony: | 6lt front 6lt rear ♠ 6lt front 5lt rear |
| Coupled 1: | 6lt ♠ 6lt |
| Coupled 2: | 6lt ♠ 6lt |
| Coupled 3: | 6lt ♠ 6lt |
| Coupled 4: | 6lt ♠ 6lt |
| Coupled 5: | 6lt ♠ 6lt |
| Coupled 6: | 6lt ♠ 6lt |
| Trail Bogie/Pony: | 4lt front 3lt rear ♠ 3lt front 3lt rear |
| Weightondrivers: | 40lt ♠ 39lt |
| Locoweight: | 61lt ♠ 59lt |
| Fueltype: | Coal |
| Fuelcap: | 6lt ♠ 41NaN1 |
| Watercap: | 1325sigfig=3NaNsigfig=3 front ♠ 1325sigfig=3NaNsigfig=3 front 540sigfig=3NaNsigfig=3 rear |
| Fireboxtype: | Round-top |
| Firearea: | 19.5square feet |
| Pitch: | 5feet |
| Diameterinside: | 4feet |
| Lengthinside: | 9feet |
| Smalltubediameter: | 152: NaN0NaN0 |
| Largetubediameter: | 15: NaN0NaN0 |
| Boilerpressure: | 1800NaN0 |
| Safetyvalvetype: | Ross-pop |
| Totalsurface: | 85.91m2 |
| Tubearea: | 60.24m2 |
| Fluearea: | 18.7m2 |
| Fireboxarea: | 6.97m2 |
| Superheatertype: | 15 elements |
| Superheaterarea: | 14.9m2 |
| Cylindercount: | Four |
| Cylindersize: | 120NaN0 bore 160NaN0 stroke |
| Valvegear: | Walschaerts |
| Valvetype: | 1401NaN1 Piston |
| Valvetravel: | 901NaN1 |
| Valvelap: | 22.221NaN1 steam lap 11NaN1 exhaust lap |
| Valvelead: | 3.51NaN1 |
| Coupling: | Johnston link-and-pin |
| Tractiveeffort: | 95kN @ 75% |
| Operator: | Alfred County Railway |
| Operatorclass: | Class NG G16A |
| Numinclass: | 2 |
| Fleetnumbers: | 141, 155 |
| Nicknames: | Red Dragon |
| Deliverydate: | 1989-1990 |
| Firstrundate: | 1989 |
The Alfred County Railway Class NG G16A 2-6-2+2-6-2 of 1989 is a steam locomotive from the South African Railways era.
Between 1937 and 1968 the South African Railways placed 34 Class 2-6-2+2-6-2 Garratt articulated steam locomotives in service. In 1989 and 1990 two of these locomotives were rebuilt to Class NG G16A by the Alfred County Railway.[1]
A total of 34 Class NG G16 2-6-2+2-6-2 locomotives were built for the South African Railways (SAR) between 1937 and 1968. Four were delivered by Société Anonyme John Cockerill of Seraing in Belgium in 1937, twenty-two by Beyer, Peacock & Company between 1939 and 1958, and the last eight by Hunslet-Taylor in Germiston, Transvaal in 1967 and 1968.[2]
The locomotives were superheated, with a superheater area of 14.9m2 and fifteen elements of 38mm outside diameter and a 31mm bore.[1]
When the four narrow gauge branchline systems in Natal were closed down by the SAR, the Weenen and Mid-Illovo lines were torn up. The Harding line was privatised in 1988 as the Alfred County Railway (ACR), operating out of Port Shepstone. The ACR was also known as the Banana Express from the tourism part of its operation.[3]
As part of the ACR's strategy to keep the narrow gauge railway competitive, two of its Class NG G16 Garratt locomotives were rebuilt using technology similar to that used by mechanical engineer David Wardale in the creation of the Class 26 Red Devil in 1980, based on developments pioneered by Argentinian engineer L.D. Porta. The Class rebuilding incorporated a gas producing combustion system (GPCS), Lempor exhausts, an improved spark arrester, lightweight multi-ring articulated piston valves, improved valve events and improved mechanical lubrication.[1] [4]
The rebuilding was done by mechanical engineer Phil Girdlestone, who was employed as Chief Mechanical Engineer of the ACR primarily for this purpose. The work was carried out at Port Shepstone. The first locomotive to undergo the treatment was the Beyer, Peacock-built no. 141 in 1989.[1]
The modifications were similar in scope to that of the Red Devil, although not as extensive. Like the Class 26, no. 141 was also painted red and nicknamed the Red Dragon. Dragon emblems were later mounted on the cab sides and bunker ends.[1]
The second locomotive, the Hunslet-Taylor-built no. 155, was rebuilt in 1990, but it retained its traditional ex-SAR black livery. Both modified locomotives were reclassified to .[1]
The GPCS is a single-stage gas producer which achieves an improved combustion and steaming rate, reduces the emission of black smoke and overcomes the problem of clinkering. The most serious waste of fuel in a conventional steam locomotive is the loss of unburned coal particles from the fuel bed through the exhaust because of the rapid flow of air through the grate.[5]
The GPCS relies on the gasification of coal on a low temperature firebed so that the gases are then fully burnt above the firebed. To achieve this, the amount of air being drawn up through the firebed is minimised, while the main sources of air required for combustion is through secondary air inlets located in the firebox sides and through the vertically sliding firedoor. The air inlets contain swirl inducers to spread the incoming air inside the firebox.[1] [4] [6]
With the GPCS, the coal is heated to drive off the volatile components which are then burned in the secondary air admitted above the grate. The result is improved combustion, thereby minimising black smoke, which is evidence of incomplete combustion and unburnt coal particles being ejected through the exhaust. Note the clear exhausts in the picture below of numbers 141 and 155 double-heading on the climb from Bongwana to Nqabeni.[1] [6]
One visible difference between the original and the rebuilt locomotives is the megaphone-shaped Lempor chimney, which contains a cylindrical mixing chamber and a wide angled diffuser. The object of the latter is to convert the kinetic energy of the combustion gas and exhaust steam mixture to a pressure as close to atmospheric as possible.[1]
Ejector pump efficiency depends on the length-to-diameter ratio of the exhaust chimney. Although less obvious, both Wardale GPCS locomotives, Class 19D no. 2644 and Class 26 no. 3450, have exactly this shape of chimney, but because of height constraints in large locomotives, their chimneys had to be doubled or even tripled to achieve the correct proportions, hence the double exhausts of the two Wardale locomotives. Narrow gauge locomotives like the Class NG G16, on the other hand, have plenty of height available for the exhaust, so a single long chimney was achievable.[1]
Other visible differences are larger mechanical lubricators and external drive from the valve spindle, a vacuum ejector exhaust muffler just in front of the safety valves, pipes conveying exhaust and ejector steam to the ashpan for mixing with the primary air, the secondary air inlets in the firebox sides with spark arresting plates outside them, and the snifting and bypass valves which were removed and blanked off since the modified locomotive drifted in mid-gear with steam supplied from the drifting valve.[1]
In comparative testing, no. 141 achieved a fuel saving of 25% compared to a standard Class Garratt, a performance which was easily maintained in regular service. Power outputs of over 700 indicated horsepower was achieved and the locomotive was probably capable of achieving a maximum of 800 indicated horsepower, some 25% more than the Class 91-000 narrow gauge diesel-electric locomotive. The improvement in performance and economy of the locomotive was brought about by the higher grate limit by means of the GPCS and better flow past the improved valves, valve motion and exhaust. Other basic elements of the locomotive remained more or less the same.[1]
The cost of the work paid off financially within twelve months and led to a proposal to develop a Class NG G17 Garratt. That proposal, however, never became reality since the line's farming produce traffic was gradually lost to road transport on the improving road network, a decline which eventually led to the ACR's demise.[4] [7]