The Parrott rifle was a type of muzzle-loading rifled artillery weapon used extensively in the American Civil War.[1]
The gun was invented by Captain Robert Parker Parrott, a West Point graduate. He was an American soldier and inventor of military ordnance. He resigned from the service in 1836 and became the superintendent of the West Point Foundry in Cold Spring, New York. He created the first Parrott rifle (and corresponding projectile) in 1860 and patented it in 1861.[2] Daniel Treadwell, who developed a method for making built-up guns in the early 1840s, tried to claim that his patent infringed on an earlier one, but in 1866 S.D.N.Y. court dismissed it, deciding that Treadwell's claim was invalidated by a 1843 British patent to John Frith.[3]
Parrotts were manufactured with a combination of cast and wrought iron. The cast iron made for an accurate gun, but was brittle enough to suffer fractures. Hence, a large wrought iron reinforcing band was overlaid on the breech to give it additional strength. There were earlier cannons designed this way, but the method of securing this band was the innovation that allowed the Parrott to overcome the deficiencies of these earlier models. It was applied to the gun red-hot and then the gun was turned while pouring water down the muzzle, allowing the band to attach uniformly.[4] By the end of the Civil War, both sides were using this type of gun extensively.
Parrott rifles were manufactured in different sizes, from the 10-pounder Parrott rifle up to the rare 300-pounder.[5] In the field, the 10- and 20-pounders were used by both armies. The 20-pounder Parrott rifle was the largest field gun used during the war, with the barrel alone weighing over 1800lb. The smaller size was much more prevalent; it came in two bore sizes: 2.9inches and 3inches. Confederate forces used both bore sizes during the war, which added to the complication of supplying the appropriate ammunition to its batteries. Until 1864, Union batteries used only the 2.9inches. The M1863, with a 3inches bore, had firing characteristics similar to the earlier model; it can be recognized by its straight barrel, without muzzle-swell. Its range was up to 2000yd with a trained crew.[6]
On June 23-24, 1862, President Abraham Lincoln made an unannounced visit to West Point, where he consulted with retired Gen. Winfield Scott regarding the handling of the Civil War and the staffing of the War Department. Following this meeting, President Lincoln visited the West Point Foundry at which the 100- and 200-pounder Parrott cannons were successfully demonstrated in live firing.[7]
Naval versions of the 20-, 30-, 60-, and 100-pounder Parrotts were also used by the Union navy.[8] The 100-pound naval Parrott could achieve a range of 6,900 yards (6,300 meters) at an elevation of 25 degrees, or fire an 80lb shell 7,810 yards (7,140 m) at 30 degrees elevation.[8]
Although accurate, as well as being cheaper and easier to make than most rifled artillery guns, the Parrott had a poor reputation for safety and they were shunned by many artillerists.[9] At the end of 1862, Henry J. Hunt attempted to get the Parrott eliminated from the Army of the Potomac's inventory, preferring the 3-inch ordnance rifle. When the Parrott gun burst in battle, gunners would chip out the jagged parts and continue firing.[10] In 1889, The New York Times called on the Ordnance Bureau of the War Department to discontinue use of the Parrott gun altogether, following a series of mishaps at the West Point training grounds.[9]
Several hundred Parrott gun tubes remain today, many adorning battlefield parks, county courthouses, and museums. The gun tubes made by Parrott's foundry are identifiable by the letters WPF (West Point Foundry), along with a date stamp between 1860 and 1889, found on the front face of the gun tube. The first production Parrott gun tube (serial number 1) still exists, and is preserved on a reproduction gun carriage in the center square of Hanover, Pennsylvania, as part of a display commemorating the Battle of Hanover. A list of many of the surviving tubes can be found at the National Register of Surviving Civil War Artillery.
The larger sizes of Parrott rifles (100-pounder and up) were deployed in coast defense from 1863 to 1900, when they were replaced by Endicott period forts and weapons. Along with Rodman guns, some were deployed shortly after the outbreak of the Spanish–American War in 1898 as a stopgap; it was feared the Spanish fleet would bombard the US East Coast.[11]
By summer 1863, Union forces became frustrated by the heavily fortified Confederate position at Fort Sumter, and brought to bear the 10inches Parrott, along with several smaller cannons. In all, two 80-pounder Whitworths, nine 100-pounder Parrotts, six 200-pounder Parrotts, and a 300-pounder Parrott[12] were deployed. It was widely believed in the north that a massive 10-inch Parrott would finally break the previously impenetrable walls of the fort, which had become the symbol of stalwart steadfastness for the Confederacy.[13]
The Washington Republican described the technical accomplishments of the 10inches Parrott:
The 3.75adj=midNaNadj=mid 24lb shot, with a muzzle velocity of 1625ft/s, strikes a target at 3500yd with a velocity of about 300ft/s (this is almost beyond the range of the weapon). In contrast, the 10adj=midNaNadj=mid 300lb shot, with a muzzle velocity of 1111ft/s, strikes the target at the same range still moving at 700ft/s, due to its much higher mass-to-drag ratio. The resulting huge difference in impact energy, 33000ftlbf for the 24lb shell, and over 2000000ftlbf for the 300lb shell, means the penetrating energy of the larger shell is 20 times that of the smaller.
In terms of the ability to punch holes in fortifications, at that long range the light 24lb shell would be expected to only breach a 6adj=midNaNadj=mid brick wall. In contrast, the greater mass and retained velocity of the 300lb shell would enable it to penetrate 6to of brick (given the quality of the material back then). The Union soldiers knew Fort Sumter's brick walls averaged about 5feet thick, and thus recognized the potential for such a cannon to help them succeed in taking back their Fort.
A famous large 8inches Parrott cannon, called the Swamp Angel, was used by federal Brigadier General Quincy Adams Gillmore to bombard Charleston, South Carolina. It was manned by the 11th Maine Volunteer Infantry Regiment.[14]
On August 21, 1863 Gillmore sent Confederate general P. G. T. Beauregard an ultimatum to abandon heavily fortified positions at Morris Island or the city of Charleston would be shelled. When the positions were not evacuated within a few hours, Gillmore ordered the Parrott rifle to fire on the city. Between August 22 and August 23, the Swamp Angel fired on the city 36 times (the gun burst on the 36th round), using many incendiary shells which caused little damage and few casualties. The battle was made more famous by Herman Melville's poem "The Swamp Angel".[15]
After the war, a damaged Parrott rifle said to be the Swamp Angel was moved to Trenton, New Jersey, where it rests as a memorial today at Cadwalader Park.[16] [17]
| Model | Length | Weight | Munition | Charge size | Maximum range at elevation | Flight time | Crew size | |
|---|---|---|---|---|---|---|---|---|
| 2.9-in (10-lb) Army Parrott | 73inches | 890lb | 10lb shell | 1lb | 5000yd at 20 degrees | 21 secs | 8 | |
| 3.0-in (10-lb) Army Parrott | 74inches | 890lb | 10lb shell | 1lb | 1830yd at 5 degrees | 7 secs | 8 | |
| 3.67-in (20-lb) Army Parrott | 79inches | 1795lb | 19lb shell | 2lb | 4400yd at 15 degrees | 17 secs | 8 | |
| 3.67-in (20-lb) Naval Parrott | 81inches | 1795lb | 19lb shell | 2lb | 4400yd at 15 degrees | 17 secs | 8 | |
| 4.2-in (30-lb) Army Parrott | 126inches | 4200lb | 29lb shell | 3.25lb | 6700yd at 25 degrees | 27 secs | 9 | |
| 4.2-in (30-lb) Naval Parrott | 102inches | 3550lb | 29lb shell | 3.25lb | 6700yd at 25 degrees | 27 secs | 9 | |
| 5.3-in (60-lb) Naval Parrott | 111inches | 5430lb | 50lb or 60lb shell | 6lb | 7400yd at 30 degrees | 30 secs | 14 | |
| 5.3-in (60-lb) Naval Parrott (breechload) | 111inches | 5242lb | 50-lb or 60lb shell | 6lb | 7400yd at 30 degrees | 30 secs | 14 | |
| 6.4-in (100-lb) Naval Parrott | 138inches | 9727lb | 80lb or 100lb shell | 10lb | 7810yd at 30 degrees (80-lb) | 32 secs | 17 | |
| 6.4-in (100-lb) Naval Parrott (breechload) | 138inches | 10266lb | 80lb or 100lb shell | 10lb | 7810yd at 30 degrees (80-lb) | 32 secs | 17 | |
| 8-in (150-lb) Naval Parrott | 146inches | 16500lb | 150lb shell | 16lb | 8000yd at 35 degrees | 180 | ? | |
| 8-in (200-lb) Army Parrott | 146inches | 16500lb | 200lb shell | 16lb | 8000yd at 35 degrees | ? | ? | |
| 10-in (300-lb) Army Parrott | 156inches | 26900lb | 300lb shell | 26lb | 9000yd at 30 degrees | 202.5 secs* | ? |
(*) This time is an educated guess, the time is unknown.Flight times appear to be extremely inaccurate. Example: 10-in (300-lb) projectile would have to average only 133ft/s to be in flight for 202 seconds to cover 9000yd. A more accurate estimate will be in the range of 30 seconds.
Contemporary rifled artillery