The New Zealand state highway network is the major national highway network in New Zealand. Nearly 100 roads in the North and South Islands are state highways. All state highways are administered by the NZ Transport Agency.
The highways were originally designated using a two-tier system, national (SH 1 to 8) and provincial, with national highways having a higher standard and funding priorities. Now all are state highways, and the network consists of SH 1 running the length of both islands, SH 2 to 5 and 10 to 59 in the North Island, and SH 6 to 8 and 60 to 99 in the South Island, numbered approximately north to south. State highways are marked by red shield-shaped signs with white numbering (shields for the former provincial highways were blue). Road maps usually number state highways in this fashion.
Of the total state highway network, New Zealand currently has 3630NaN0 of motorways and expressways with grade-separated access and they carry ten percent of all New Zealand traffic. The majority of the state highway network is made up of single-carriageway roads with one lane each way and at-grade access.
In the early days all roads were managed by local road boards. Initially they were set up by the Provinces. For example, Auckland Province passed a Highways Act in 1862 allowing their Superintendent to define given areas of settlement as Highways Districts, each with a board of trustees elected by the landowners. Land within the boundaries of highway districts became subject to a rate of not more than 1/- an acre, or of 3d in the £ of its estimated sale value and that was to be equalled by a grant from the Province.[1] By 1913 the government was collecting £21,000 in duty on cars, but spending £40,000 on roads.[2]
The idea of a national network of highways did not emerge until the early twentieth century, when a series of pieces of legislation was passed to allow for the designation of main highways (starting with the Main Highways Act 1922, followed by gazetting of roads[3]) and state highways (in 1936). This saw the National Roads Board, an arm of the Ministry of Works, responsible for the state highway network.
From 1989 to 2008, state highways were the responsibility of Transit New Zealand, a Crown entity. In 1996 the funding of the network was removed from the operational functions with the creation of Transfund New Zealand, which then merged with the Land Transport Safety Authority to create Land Transport New Zealand. That was done to ensure that funding of state highways was considered on a similar basis to funding for local roads and regional council subsidised public transport. In August 2008, Transit and Land Transport NZ merged to become the NZ Transport Agency.
Every five years the NZ Transport Agency will embark on a state highway review to consider whether the existing network should be expanded or reduced, according to traffic flows, changes in industry, tourism and development.
From 2009 many new road schemes were classed as Roads of National Significance and, from 2020, as part of the New Zealand Upgrade Programme.
Since 2013, the NZTA has used the One Network Road Classification (ONRC) system to classify state highways and local roads. There are five categories for state highways, with an additional sixth category (Access) used only by local roads. The categories are as follows:[4] [5] [6]
From 2006 information, the busiest stretch of SH 1 was just south of the Auckland Central Motorway Junction, on/near the Newmarket Viaduct, with over 200,000 vehicles (either way) each day. The least busy parts of the network (excluding off-ramps and on-ramps) are on SH 43 north-east of Whangamōmona, with fewer than 120 vehicles (counting both directions) in a day.[7]
The only remaining unsealed sections of state highway are 12km (07miles) of SH 43[8] and 20km (10miles) of SH 38,[9] though 38% of other roads remain unsealed.[10]
Every year the New Zealand Transport Agency produces a booklet titled AADT Data, average annualised daily traffic, that gives traffic volumes on all state highways from their automated vehicle recording system.[11]
State highways are marked with posts at irregular intervals giving the distance in kilometres from the start of the highway. Until recently, all bridges on the network had at each end a small plaque showing the distance from the start of the highway, usually in the form of a number in kilometres, an oblique stroke, and a further number in kilometres, accurate to the nearest 10 metres. A plaque marked 237/14.12, for example, indicated that the bridge was 14.120NaN0 past a set distance post, that post being 2370NaN0 from the start of the highway. In about 2004 these plaques were replaced by a new system, which gives each bridge a single number showing the distance from the start of the highway in hundreds of metres. Under the new system the bridge above would be numbered 2511, as it is 2510NaN0 km from the start of the highway. Motorway on- and off-ramps are numbered using the same system.
In this way, travellers can accurately assess their location, and road authorities can identify each bridge uniquely.
Sometimes, houses with RAPID numbering can also be used to determine the position. For example, house number 1530 is 15.30NaN0 from the start of the highway.
In early 2008, Transit New Zealand unveiled KiwiRAP (the New Zealand Road Assessment Programme) in cooperation with other government agencies and the New Zealand Automobile Association. The system, based on similar programs overseas, categorises New Zealand state highways according to the safety of discrete 'links' (sections of the network, with a total of 10,856 km of highways separated into 172 links ranging in length from 2.40NaN0 to 3180NaN0). These are graded according to their 'individual risk' and their 'collective risk' based on historical crash data and traffic volumes.[12]
The individual risk is based on the likelihood of a single driver experiencing an accident while travelling the link in question. As of 2008, the three least safe sections of the network based on individual risk were State Highway 62 from Spring Creek to Renwick (Marlborough), State Highway 37 to Waitomo Caves and State Highway 94 from Te Anau to Milford Sound.[12]
The collective risk is based on the total number of crashes that occurred on the link, which pushes safer but very highly travelled sections of the network to the top of the statistical category. As of 2008, the three least safe sections of the network based on collective risk were all on State Highway 2, on the sections from Napier to Hastings, Mount Maunganui to Paengaroa and Bay View to Napier.[12]
Both categories of assessment are to be used as an advisory tool for both drivers to inform them of dangerous road sections as well as to allow traffic controlling authorities to prioritise maintenance and safety improvements.
The 2015–18 National Land Transport Programme aimed to invest $3.2bn (23% of the NLTP total) in safety, including $960m for policing, $132m for road safety promotion and $103m for rural SH safety.[13] The Safe Roads Alliance is carrying out rural work on SH 1 (Waikato Expressway, Te Teko-Awakeri), SH 1B (Taupiri-Gordonton), SH 3 (Ohaupo-Te Awamutu, Waitomo-Te Kuiti), SH 11 (Airfield-Lily Pond), SH 12 (Dargaville-Tokatoka), SH 16 (Brigham Creek-Waimauku), SH 23 (Hamilton-Raglan), SH 27 (SH 26-SH 24) and SH 34 (SH 30 to Kawerau). The Alliance is using speed reductions, wire rope barriers, wide centrelines, rumble strips, better warning signs and shoulder widening.[14]
See main article: State Highway 1 (New Zealand).
State Highway 1 can be considered as a single highway running the length of both main islands, broken in the middle by the ferry connection at Cook Strait. It connects six of the seven largest urban areas and includes the country's busiest stretch of road.
Many sections of state highway provided are marketed as tourist highways, sometimes jointly with local roading providers. Transit maintains traffic signs on and near state highways to help promote these routes.[15] [16] [17] These include: