Junkers Jumo 205 Explained

The Jumo 205 aircraft engine was the most famous of a series of aircraft diesel engines produced by Junkers. The Jumo 204 first entered service in 1932. Later engines of this type comprised the experimental Jumo 206 and Jumo 208, with the Jumo 207 produced in some quantity for the Junkers Ju 86P and -R high-altitude reconnaissance aircraft, and the 46-meter wingspan, six-engined Blohm & Voss BV 222 Wiking flying boat.[1] All three of these variants differed in stroke and bore and supercharging arrangements. In all, more than 900 of these engines were produced, in the 1930s and through most of World War II.

Design and development

These engines all used a two-stroke cycle with 12 pistons sharing six cylinders, piston crown to piston crown in an opposed configuration. This unusual configuration required two crankshafts, one at the bottom of the cylinder block and the other at the top, geared together. The pistons moved towards each other during the operating cycle. The intake ports were located at one end of the cylinder, whereas the exhaust ports were at the other end. This made one piston effectively control the intake, and the other control the exhaust.[2] Two cam-operated injection pumps per cylinder were used, each feeding two nozzles, for four nozzles per cylinder in all.

As is typical of two-stroke designs, the Jumos used no valves, but rather fixed intake and exhaust port apertures cut into the cylinder liners during their manufacture, which were uncovered when the pistons reached a certain point in their strokes. Normally, such designs have poor volumetric efficiency because both ports open and close at the same time and are generally located across from each other in the cylinder. This leads to poor scavenging of the burnt charge, which is why valveless two-strokes generally produce smoke and are inefficient.

The Jumo largely addressed this problem through a clever arrangement of the ports. The intake port was positioned under the "lower" piston, while the exhaust port was under the "upper" piston. The lower crankshaft operated 11° behind the upper, causing the exhaust ports to open and close first, which allowed for proper scavenging. This design enabled the two-stroke Jumos to run nearly as cleanly and efficiently as four-stroke engines with valves, but with significantly less complexity.

Some downside exists to this system, as well. For one, since matching pistons were not closing at quite the same time, but one ran "ahead" of the other, the engine could not run as smoothly as a true opposed-style engine. In addition, the power from the two opposing crankshafts had to be geared together, adding weight and complexity, a problem the design shared with H-block engines.

In the Jumo, these problems were avoided to some degree by taking power primarily from the "upper" shaft, somewhat offset upwards on the engine's front end. All of the accessories, such as fuel pumps, injectors and the scavenging compressor, were run from the lower shaft, meaning over half of its power was already used up. What was left over was then geared to the upper shaft, which ran the engine's propeller.

In theory, the flat layout of the engine could have allowed it to be installed inside the thick wings of larger aircraft, such as airliners and bombers. Details of the oil scavenging system suggest this was not possible and the engine had to be run "vertically", as it was on all designs using it.

Because the temperature of the exhaust gases of the Jumo diesel engines was substantially lower than that of comparable carburettor engines, it was easier to add a turbocharger for higher altitudes. This was explored in the Jumo 207 which used the energy of the exhaust gases to increase the power at high altitudes. The turbocharger was combined with a mechanically driven blower, so that the turbocharger creates the first stage of compression, and the mechanical blower the second stage. At low load and startup, the turbocharger does not contribute to supercharging the engine, but the mechanical blower provides enough air for the engine to operate. At high load, however, the turbocharger receives sufficient quantities of exhaust gas, which means that it alone can provide enough supercharging without the need of the inefficient mechanical blower. The addition of the turbocharger to the mechanical blower made the engine more powerful without significantly increasing its specific fuel consumption.[3]

Variants

Jumo 205:
  • Jumo 206: An experimental version. Development halted in favour of the Jumo 208.
  • Jumo 207A: High-altitude version with two inline centrifugal superchargers and a precooler.
  • Jumo 207 B-3 had an improved turbocharger and featured GM-1 nitrous oxide injection.
  • Jumo 207 C: optimised for medium altitude. Produced in small series for the Blohm & Voss BV 222.
  • Jumo 207 D: optimised for medium altitude. Cylinder diameter increased from 105 mm to 110 mm. Maximum power at ground level was 1,200 hp (880 kW). Prototypes only.
  • Jumo 207 E: similar to the 207 C but greater performance at high altitude. Project only.
  • Jumo 207 F: optimised for higher altitude. Two-stage turbocharger. Development stopped in 1942.[4]
  • Jumo 208: with greater displacement, resulting in a maximum power of 1,500 hp (1,100 kW) at medium altitude. Bench tested but not produced.
  • Jumo 218: A 12-cylinder version, the Jumo 218, was designed but never built.
  • Jumo 223
  • A single 24-cylinder four-crankshaft Jumo 223 was built and tested.
    Jumo 224: Larger than the Jumo 223 by combining 4 Jumo 207 C engines.
  • CLM Lille 6As: A license-built version from CLM Lille, delivering 650hp[5] [6] (CLM was the predecessor to the engine maker, a sister company to Peugeot)
  • CLM Lille 6BrS: A developed version of the 6As used to power the Bernard 86[6]
  • Applications

    The Jumo 205 powered early versions of the Junkers Ju 86 bomber, but was found too unresponsive for combat and liable to failure at maximum power, common for combat aircraft. Later versions of the design also used the engine for extreme high-altitude use, as with the Ju 86P and -R versions for high-altitude reconnaissance over the British Isles. In January 1940, the Luftwaffe tested the prototype Ju 86P with Jumo 207A-1 turbocharged diesel engines. It was far more successful as a power unit for airships, for which its characteristics were ideal, and for noncombat applications such as the Blohm & Voss Ha 139 airliner. Its more fuel-efficient operation lent itself for use on Germany's few maritime patrol flying-boat designs during World War II, such as the BV 138 and BV 222.

    Applications list

    Other notable opposed-piston engines

    See also

    opposed piston diesel of similar operation

    license built version of the Jumo 204

    developed from the Naper Culverin

    American 9-cylinder radial diesel aero engine first flown in 1929.

    Further reading

    External links

    Notes and References

    1. Web site: Smithsonian National Air & Space Museum - Junkers Jumo 207 D-V2 In-line 6 Diesel Engine . 2016-03-20 . airandspace.si.edu . Smithsonian Institution . December 29, 2017 . 2017-12-29 . https://web.archive.org/web/20171229231648/https://airandspace.si.edu/collection-objects/junkers-jumo-207-d-v2-line-6-diesel-engine . dead .
    2. Paul Henry Schweitzer: Scavenging of two-stroke cycle Diesel engines, Macmillan, New York 1949, p. 8
    3. Paul Henry Schweitzer: Scavenging of two-stroke cycle Diesel engines, Macmillan, New York 1949, p. 19
    4. Reinhard Mueller (2006) Junkers Flugtriebwerke.
    5. POWER at the SALON j Detailed Review of the British and Continental Engines at the Show : A Remarkable Variety of Types. Flight. 26 November 1936. 577. 14 March 2015.
    6. Web site: Characteristiques et Description du Moteur Type Lille 6Brs de 600CV. 6 November 2017. fr.