The 12Z differed from the earlier 12Y primarily in the use of four valves per cylinder operated by dual overhead cams, as opposed to two valves operated by a single camshaft. This gave the cylinders considerably better volumetric efficiency and faster operation, raising the RPM from 2,400 to 2,700. As with the later variants of the 12Y, the engine was designed to run on 100 octane fuel as well as operate at a higher 7.0:1 compression ratio. After the initial prototypes, fuel injectors built by Lavalette-Bosch would replace the original carburetors, raising the power from 1,000 to 1,300 hp (750 to 970 kW) at sea level.
The engine continued to use a single-stage, single-speed centrifugal supercharger and therefore lacked the all-altitude performance of German and British designs. But swapping the mediocre HS No.1 supercharger for the larger Szydlowsky-Planiol supercharger tuned for a higher critical altitude improved high-altitude performance considerably, delivering 1,500 hp (1,120 kW) at 6400m (21,000feet) as opposed to 930 hp (690 kW) at 900m (3,000feet) for the 12Y-45.
Small prototype runs started in 1939, and were fitted to the French Air Force's front-line fighter aircraft, the M.S.410 and D.520, creating the M.S.450 and D.524 respectively. Production of the main model, the 12Zter, was still not ready at the time of the armistice when the factory had to move from Bois-Colombes to Tarbes. The earliest full-scale production order of 70 engines was placed in 1941, intended to support the first half of an order for 105 D.520Zs that was not permitted by the occupation government. Initial production instead was undertaken in Hispano-Suiza's Spanish factories in Barcelona where they were intended for the HA-1109. In 1943, La Hispano-Suiza received an order for 120 engines from the Spanish Air Force, but by late 1947 only 50 were completed. Rather than operate with 100/130 octane fuel as used by the French, the Spanish 12Zs were tuned to operate with 92 octane fuel. The lower grade fuel the power dropped slightly to 1,280 hp (950 kW) at 2,600 rpm (1,479 hp (1,100 kW) maximum take-off). Of these first 50 12Zs, three would be given to France post-war to speed up aircraft development.
Development would continue in Barcelona after the occupation of Southern France in 1942, but then would return to France after liberation in 1944. With the reestablishment of Hispano-Suiza in France, development and production would quickly pick back up in 1945 with the 12Z-17 family of engines and end in 1950 after producing about 200 engines.[1] Spanish production would continue in 1948 with Hispano-Suiza partnered with ENASA for an order of 280 new 12Z-17s and 50 rebuilt 12Z-M. Of the 70 incomplete engines from the prior order, ENASA delivered 12 12Zs by 1950 and converted 58 to 12Z-Ms. Due to poor reliability and schedule issues, the order for 280 engines was reduced to 100, and only 104 12Z-17s were delivered by 1955 when the contract was canceled.
With development and production being split between La Hispano Suiza of Barcelona and Hispano Suiza of Bois-Colombes and Tarbes, there were multiple designations for the same model created for the 12Z and its variants. Spanish serial numbers were in the 50XXX range and French serial numbers were in the 10XXX range.