The GVV Dal Molin Roma or Mori Anfibio Roma was a single-seat, amphibious flying boat glider built in Italy in 1933. Only one was constructed.
The Roma was designed by Angelo Mori and built by the Grupo Volo a Vela Tommaso Dal Molin (English: Tommaso Dal Molin Gliding Group) in Varese. It was a cantilever high-wing monoplane, its high aspect ratio, single spar wing constructed with a wooden frame and covered in plywood and fabric. It was mounted with some dihedral and in plan was straight tapered with elliptical tips. Ailerons occupied about half the span.
The fuselage of the Roma was flat sided aft of the wing, which sat on top of it. Between the trailing edge and close to the tail it was fabric covered; the rest, like the forward fuselage, was skinned with ply. All the fuselage surfaces were treated with ship's waterproof paint. The cantilever horizontal tail, mounted on the fin just above the fuselage, was slightly straight tapered. The fin was very small, serving only to mount a large, slightly curved, balanced rudder. This extended below the fuselage, moving within an elevator cut-out and partly protected by a ventral fin. The cockpit was immediately ahead of the wing leading edge, with a curved upper fuselage reaching forwards to the nose. Different cockpit enclosures were used, though the order is uncertain. One placed the pilot under a separable, multi framed canopy; with the other the pilot after entry was surrounded by a demountable ply covering which filled the larger aperture, allowing his head to emerge from within an open, circular, collared hole. The interior was lit by glazing in the cover just in front of the seat.
The Roma was an amphibian and had a single step, flying boat style hull with the step under mid-chord. Small stabilizing floats were mounted under the wings at about two-thirds span, each attached by two spanwise parallel pairs of V-struts. Land operation used a standard glider skid, running from just aft of the nose to aft of the trailing edge. A dolly was used for launches.
The Roma's first flight was in May 1933, flown by Romeo Sartori from Lake Schiranna near Varese. Plinio Rovesti later flew it from the summit of the Campo dei Fiori di Varese to Lake Maggiore, about 16abbr=onNaNabbr=on away. On 16 September 1934 the Roma, flown again by Rovesti led eight Anfibio Vareses (another Mori design), bungee launched, from the Campo dei Fiori to alight at Schiranna. Rovesti continued to fly it from Campo dei Fiori and from Mottarone over local lakes. During World War II, the Roma was stored at Vizzola Ticino but was burned by retreating German occupation forces.