F region explained

The F region of the ionosphere is home to the F layer of ionization, also called the Appleton–Barnett layer, after the English physicist Edward Appleton and New Zealand physicist and meteorologist Miles Barnett. As with other ionospheric sectors, 'layer' implies a concentration of plasma, while 'region' is the volume that contains the said layer. The F region contains ionized gases at a height of around 150–800 km (100 to 500 miles) above sea level, placing it in the Earth's thermosphere, a hot region in the upper atmosphere, and also in the heterosphere, where chemical composition varies with height. Generally speaking, the F region has the highest concentration of free electrons and ions anywhere in the atmosphere. It may be thought of as comprising two layers, the F1 and F2 layers.

The F-region is located directly above the E region (formerly the Kennelly-Heaviside layer) and below the protonosphere. It acts as a dependable reflector of HF radio signals as it is not affected by atmospheric conditions, although its ionic composition varies with the sunspot cycle. It reflects normal-incident frequencies at or below the critical frequency (approximately 10 MHz) and partially absorbs waves of higher frequency.

F1 and F2 layers

The F1 layer is the lower sector of the F layer and exists from about 150 to 220 km (100 to 140 miles) above the surface of the Earth and only during daylight hours. It is composed of a mixture of molecular ions O2+ and NO+, and atomic ions O+.[1] Above the F1 region, atomic oxygen becomes the dominant constituent because lighter particles tend to occupy higher altitudes above the turbopause (at ~90 km, 56 miles). This atomic oxygen provides the O+ atomic ions that make up the F2 layer.The F1 layer has approximately 5 × 105 e/cm3 (free electrons per cubic centimeter) at noontime and minimum sunspot activity, and increases to roughly 2 × 106 e/cm3 during maximum sunspot activity. The density falls off to below 104 e/cm3 at night.

Usage in radio communication

Critical F2 layer frequencies are the frequencies that will not go through the F2 layer.[3] [4] Under rare atmospheric conditions, F2 propagation can occur, resulting in VHF television and FM radio signals being received over great distances, well beyond the normal 40- reception area.

References

  1. Book: Kamide. Yohsuke. Chian. Abraham C.-L.. Handbook of the solar-terrestrial environment. limited. 2007. Springer. Berlin. 978-3-540-46315-3. 199.
  2. Adrian Weiss, Ionospheric Propagation, Transmission Lines, and Antennas for the QRP DXer, Milliwatt QRP Books, 2011, pp. 1-16, 1-22 to 1-24.
  3. Web site: Near-Real-Time F2-Layer Critical Frequency Map. spacew.com. 2014-12-07. 2014-06-28. https://web.archive.org/web/20140628231212/http://www.spacew.com/www/fof2.html. dead.
  4. Book: The Electronics of Radio. Rutledge, D.. 1999. Cambridge University Press. 9780521646451. 2–237. 2014-12-07.