Explorer S-1 | |
Names List: | Explorer S-1 Explorer 7X NASA S-1 |
Image Alt: | Technical drawing of a satellite with labels |
Mission Type: | Earth science |
Operator: | NASA |
Cospar Id: | EXP-7X |
Mission Duration: | Failed to orbit |
Spacecraft: | Explorer S-1 |
Spacecraft Type: | Science Explorer |
Spacecraft Bus: | S-1 |
Manufacturer: | Jet Propulsion Laboratory |
Launch Date: | 16 July 1959, 17:37:03 GMT |
Launch Rocket: | Juno II (AM-16) |
Launch Site: | Cape Canaveral, LC-5 |
Launch Contractor: | Army Ballistic Missile Agency |
Destroyed: | Failed to orbit |
Orbit Reference: | Geocentric orbit (planned) |
Orbit Regime: | Low Earth orbit |
Orbit Inclination: | 49.9° |
Orbit Period: | 112.7 minutes |
Apsis: | gee |
Instruments: | Ground Based Ionospheric Heavy Primary Cosmic Rays Micrometeorite Solar X-Ray and Lyman-Alpha Radiation Thermal Radiation Trapped Radiation and Solar Protons |
Programme: | Explorer program |
Previous Mission: | Explorer 5 |
Next Mission: | Explorer 6 |
Explorer S-1, also known as NASA S-1 or Explorer 7X,[1] was a NASA Earth science satellite equipped with a suite of scientific instruments to study the environment around the Earth. The spacecraft and its Juno II launch vehicle were destroyed five seconds after launch on 16 July 1959, in a spectacular launch failure caused by complications with the launch vehicle's power supply. A relaunch of the mission in October 1959, Explorer 7 (S-1A), was successful.
The mission was planned to be the sixth flight of the Explorer program, designated NASA S-1 and Explorer 7X retrospectively.[2] The objectives of the mission were to measure the Earth's radiation balance, and the abundance of Lyman-alpha X-rays and cosmic rays, including heavy primary cosmic rays.[2] The spacecraft was also designed as a test bed for satellite capabilities, being equipped with instruments to measure the spacecraft's temperature, micrometeorite impacts and the erosion of solar cells exposed to the vacuum of space.[2] The spin-stabilized spacecraft was in size, and had a launch mass of .[2] [3] The spacecraft's power was drawn from a bank of fifteen nickel–cadmium batteries recharged by 3,000 solar cells mounted on the exterior of the spacecraft.[3]
The spacecraft was mounted atop a Juno II launch vehicle with the serial AM-16.[4] It was launched on 16 July 1959, at 16:37:03 GMT, from Cape Canaveral Launch Complex 5 (LC-5).[5] Immediately after liftoff, a short circuit of the launch vehicle's guidance system caused the Rocketdyne S-3D engines to gimbal, tilting the rocket sharply to the west before almost flipping upside down.[3] [6] Five-and-a-half seconds after launch, the Range Safety Officer destroyed the launch vehicle. The launch vehicle's payload impacted the ground northwest of the launch site, resulting in a massive fireball.[3] [6]
In an investigation conducted after the launch failure, it was found that the short circuit occurred between two diodes in the launch vehicle's power supply inverter voltage regulator, cutting off power to the guidance system and causing a full gimbal.[6] Circuit board designs for the Juno II, and similar launch vehicles, subsequently used conformal coating to reduce the chances for a recurrence.[6] The launch, described by commentators as "infamous" and "one of the most spectacular failures ever seen at [Cape Canaveral]",[3] [6] [7] was the third of the Juno II launch vehicle, after it failed to carry Pioneer 3 into heliocentric orbit in December 1958,[8] [9] but succeeded in the same objective in March 1959, carrying the United States' first interplanetary mission, Pioneer 4.[10] [11] S-1 was the first geocentric orbit launch attempt for the launch vehicle; its second attempt on 14 August 1959, carrying the Beacon 2 inflatable sphere experiment to low Earth orbit, also failed.[6] [12] Eventually, both the Juno II and a re-launch of the S-1 mission, designated Explorer 7 or S-1A, found success on 13 October 1959.[13] [14] The satellite, which ended its mission in August 1961, is still orbiting the Earth today.[12] [15]