| Emergency Planning and Community Right-to-Know Act | |
| Fullname: | Emergency Planning and Community Right-to-Know Act |
| Acronym: | EPCRA |
| Enacted By: | 99th |
| Effective Date: | October 17, 1986 |
| Public Law Url: | http://149.168.212.15/serc/SARA-TITLE-III.PDF |
| Cite Public Law: | 99-499 |
| Cite Statutes At Large: | 100 Stat. 1728 |
| Acts Amended: | CERCLA |
| Title Amended: | 42 |
| Sections Created: | 11001-11050 |
| Leghisturl: | https://www.congress.gov/bill/99th-congress/house-bill/2005 |
| Introducedin: | House of Representatives |
| Introducedbill: | H.R.2005 |
| Introducedby: | James R. Jones (D–OK) |
| Introduceddate: | April 4, 1985 |
| Passedbody1: | House of Representatives |
| Passeddate1: | May 14, 1985 |
| Passedvote1: | 413-0 |
| Passedbody2: | Senate |
| Passeddate2: | September 26, 1985 |
| Passedvote2: | 86-13 |
| Conferencedate: | October 3, 1986 |
| Passedbody3: | Senate |
| Passeddate3: | October 3, 1986 |
| Passedvote3: | 88-8 |
| Passedbody4: | House of Representatives |
| Passeddate4: | October 8, 1986 |
| Passedvote4: | 386-27 |
| Signedpresident: | Ronald Reagan |
| Signeddate: | October 17, 1986 |
The Emergency Planning and Community Right-to-Know Act of 1986 is a United States federal law passed by the 99th United States Congress located at Title 42, Chapter 116 of the U.S. Code, concerned with emergency response preparedness.
On October 17, 1986, President Ronald Reagan signed into law the Superfund Amendments and Reauthorization Act of 1986 (SARA). This act amended the Comprehensive Environmental Response, Compensation, and Liability Act of 1980 (CERCLA), commonly known as Superfund.
A free-standing law, the Emergency Planning and Community Right-to-Know Act of 1986 (EPCRA) was commonly known as SARA Title III. Its purpose is to encourage and support emergency planning efforts at the state and local levels and to provide the public and local governments with information concerning potential chemical hazards present in their communities.
See also: Bhopal disaster.
During the early morning hours of December 3, 1984, a Union Carbide plant in a village just South of Bhopal, India released approximately forty tons of Methyl Isocyanate (MIC) into the air. Used in the manufacture of pesticides, MIC is a lethal chemical. The gas quickly and silently diffused over the ground and, in the end, killed, by some estimates, upwards to 5,000 people and injured 500,000 more.[1] The only other place in the world that Union Carbide manufactured MIC is at its Institute plant in the Kanawha Valley of West Virginia.
A week after the Bhopal accident, on December 11, 1984, Hank Karawan, then plant manager of the Union Carbide's Institute facility, held a press conference at which he expressed his confidence in the safety of the Institute plant's operations:[2]
All of us here at the Institute plant have been deeply saddened by the tragic event in India and we extend our sympathy to all the people in the city of Bhopal. I am pleased to have the opportunity to make a point here this morning. Employees of the Institute plant have been manufacturing MIC in an effective and safe manner for seventeen years. We are extremely proud of that safety record. We are confident in the ability of our trained, dedicated, skilled, and experienced people. We are confident in the equipment that we operate, the safety precautions that we utilize, the monitoring systems that we have, and our plant emergency preparedness.
Despite Mr. Karawan's vote of confidence for the safety of the MIC operations at his plant, Union Carbide elected to shut down production of the deadly chemical until it could make $500 million worth of safety improvements. On May 4, 1985, Union Carbide resumed production of MIC. On August 11, 1985, on the heels of the completion of the safety improvement program just a few months before, 500 gallons of aldicarb oxime and highly toxic MIC leaked from the Institute plant. Although no one was killed, 134 people living around the plant were treated at local hospitals.
Both the Bhopal and the Institute incidents underscored the reality of modern-day chemical production—no matter what safety precautions are taken, no matter how well trained a plant's employees may be, and no matter how prepared a plant may be to handle an emergency situation, accidents may still occur. Indeed, around the time of the Bhopal disaster, 6,928 chemical accidents occurred in the United States within a five-year period. In response to this growing threat, the United States Congress passed the Emergency Planning and Community Right-to-Know Act (EPCRA) in 1986.[3]
In November 1986, the United States Congress passed the Emergency Planning and Community Right-to-Know Act ("EPCRA" or "the Act") to help America's communities "deal safely and effectively with the many hazardous substances that are used throughout our society."[4] The purpose of the Act is two-fold: (1) to encourage and support emergency planning for responding to chemical accidents; and (2) to provide local governments and the public with information about possible chemical hazards in their communities. To facilitate cooperation between industry, interested citizens, environmental and other public-interest organizations, and government at all levels, the Act establishes an ongoing "forum" at the local level called the Local Emergency Planning Committee (LEPC). LEPCs are governed by the State Emergency Response Commission (SERC) in each state.
Under the Emergency Planning and Community Right-to-Know Act, SERCs and LEPCs are charged with four primary responsibilities:
EPCRA does not place limits on which chemicals can be stored, used, released, disposed, or transferred at a facility. It only requires a facility to document, notify, and report information. Each section of the law, however, applies different requirements, has different deadlines and covers a different group of chemicals.
These sections are to ensure that state and local communities are prepared to respond to potential chemical accidents. As a first step, each state had to establish a State Emergency Response Commission (SERC). In turn, the SERC designated local emergency planning districts. For each district, the SERC appoints, supervises and coordinates the activities of a Local Emergency Planning Committee (LEPC). The LEPC must, in turn, develop an emergency response plan for its district and review it annually. The membership of the LEPC includes representatives of public and private organizations as well as a representative from every facility subject to EPCRA emergency planning requirements.[6]
The plan developed by the LEPC must:
Determining if a facility is subject to the EPCRA emergency planning requirements is straightforward. The Environmental Protection Agency (EPA) has published a list of "extremely hazardous substances (EHS)." For each EHS, the list includes the name, the Chemical Abstract Service number of the substance, and a number called a threshold planning quantity (TPQ). The TPQ, expressed in pounds, is the critical number. If a facility has within its boundaries an amount of an extremely hazardous substance equal to or in excess of its threshold planning quantity, the facility is subject to the EPCRA emergency planning requirements and must notify both the SERC and the LEPC of this fact. The facility must also appoint an emergency response coordinator who will work with the LEPC on developing and implementing the local emergency plan at the facility.
A facility may be subject to these reporting requirements even if it is not subject to the provisions of Sections 301–303. This section applies to any facility which stores, produces or uses a "hazardous chemical" (any chemical which is a physical hazard or a health hazard) and releases a reportable quantity (RQ) of a substance contained in either of the following two tables published by the EPA in the Code of Federal Regulations:
The RQ is the critical number that determines if a release must be reported. This is a number expressed in pounds that is assigned to each chemical in the above-mentioned tables. If the amount of a chemical released to the environment exceeds the reportable quantity, the facility must immediately report the release to the appropriate LEPC and SERC and provide a written follow-up as soon as practicable. Immediate notification must include the following:
In addition to immediate notification, facilities are required to provide a follow-up report, in writing, "update(ing) the original notification, provid(ing) additional information on response actions taken, known or anticipated health risks, and, if appropriate, advice regarding any medical care needed by exposure victims."[8] Failure to notify the proper authorities may result in civil penalties of up to $25,000 per day for each day of non-compliance and criminal penalties of up to $25,000 in fines and prison sentences of up to two years.
Of course there are exceptions. A release which results in exposure to persons solely within the facility boundary or is a federally permitted release does not have to be reported. Also, continuous pesticide and radionuclide releases meeting specified conditions are exempt.
The purpose of these requirements is to increase community awareness of chemical hazards and to facilitate emergency planning. This section applies to any facility that is required by the Occupational Safety and Health Administration (OSHA) under its Hazard Communication Standard to prepare or have available a Safety Data Sheet (SDS) for a hazardous chemical (See II above for definition) or that has on-site, for any one day in a calendar year, an amount of a hazardous chemical equal to or greater than the following threshold limits established by the EPA:
If a facility is subject to reporting under these sections, it must submit information to the SERC, the LEPC and the local fire department with jurisdiction over the facility under two categories: SDS reporting and inventory reporting.
SDS reporting requirements specifically provide information to the local community about mixtures and chemicals present at a facility and their associated hazards. For all substances whose on-site quantities exceed the above threshold limits, the facility must submit the following:
Inventory reporting is designed to provide information on the amounts, location and storage conditions of hazardous chemicals and mixtures containing hazardous chemicals present at facilities. The inventory report has two forms. The Tier One form, the simpler of the two, contains aggregate information for applicable hazard categories and must be submitted yearly by March 1. The Tier One form is no longer accepted by any state. The Tier Two form contains more detailed information, including the specific names of each chemical. This form is submitted upon request of any of the agencies authorized to receive the Tier One form. It can also be submitted yearly in lieu of the Tier One Form.
Under this section, The EPA is required to establish the Toxics Release Inventory (TRI), an inventory of routine toxic chemical emissions from certain facilities. This inventory is intended to inform the public about releases of toxic chemicals.[9] The data gathered is also intended to assist in research and development of regulations, guidelines, and standards. The original data requirements for the TRI, specified in SARA Title III, have been greatly expanded by the Pollution Prevention Act of 1990. The TRI must now also include information on source reduction, recycling and treatment.
To obtain this data, EPCRA requires each affected facility to submit a Toxic Chemical Release Inventory Form (Form R) to the EPA and designated state officials each year on July 1. A facility must file a Form R if it:
On October 29, 1999, EPA published a final rule (64 FR 58666) adding certain chemicals and chemical categories to the EPCRA section 313 list of toxic chemicals and lowering the reporting threshold for persistent bioaccumulative toxic (PBT) chemicals. On January 17, 2001 EPA published a final rule (66 FR 4500) that classified lead and lead compounds as PBT chemicals and lowered their reporting thresholds.
In December 2006, the EPA finalized a new TRI Rule which expands eligibility for use of the Form A Certification Statement in lieu of the more detailed Form R. Details about this final rule can be found on the EPA website under TRI Reporting.
Since April 30, 1993, the United States Air Force, in accordance with AFR 355-1, "Disaster Preparedness, Planning and Operations," has voluntarily complied with Sections 303 and 304 of EPCRA in spite of the fact that federal facilities were initially exempt from its requirements. On August 3, 1993, President Clinton signed Executive Order 12856, "Federal Compliance With Right-to-Know Laws and Pollution Prevention Requirements." This Executive Order requires federal agencies, including the Department of Defense, to fully comply with all provisions of EPCRA and the Pollution Prevention Act with one notable exception: the reporting requirements under Section 313. Currently, a non-federal facility must file a Form R only if it is in a specified Standard Industrial Classification (SIC) Code. This exclusion does not apply to federal agencies. Federal agencies will comply with the provisions of Section 313 regardless of the SIC code that applies to their facilities.
The EPA's guide provides a useful description of the four groups of chemicals subject to reporting under the Emergency Planning and Community Right-to-Know Act: