The sisters participated in the Battle of Jutland in May 1916 where was sunk with all hands. spent the next year on blockade duties in the North Sea before she was transferred to the Atlantic Ocean on convoy escort duties for the rest of the war. She was sold for scrap in 1920.
After the preceding, the Royal Navy rethought how it planned to use its armoured cruisers. It decided that they were going to form a fast wing of the battlefleet, which meant that they required heavier armour and armament to fight their counterparts in opposing fleets (thus necessitating larger hulls and higher costs). Two armoured cruisers were planned for the 1902–1903 Naval Programme and the newly appointed Director of Naval Construction, Philip Watts designed what naval historian Oscar Parkes called: "cruiser editions of the s". In these, his first design, he perpetuated the worst feature of the designs by his predecessor, Sir William White, by placing the secondary armament of 6inches guns in embrasures a deck below the main armament which meant that the guns were inoperable in anything more than a dead calm sea.[1] A solution for this problem was offered after construction began when Watts learned that the ships would be lighter than expected and that weight would be available to replace the six-inch guns with 7.5inches guns raised to the same deck as the main armament. The change would cost a total of £398,000 for the two ships, far too expensive for the Board of Admiralty, so it was rejected on 30 March 1904.[2]
The Duke of Edinburgh-class ships were designed to displace 13550LT, but they proved to be significantly lighter as built, displacing 12590LT at normal load and 13965LT fully loaded. The ships had an overall length of 505feet and a length between perpendiculars of 480abbr=onNaNabbr=on. They had a beam of 73feet and a deep draught of 26feet forward and 27feet aft. The class was over 30feet longer overall than the Devonshires and displaced over 2500LT more.[3]
The ships' complement was 769 officers and enlisted men.[4] They rolled quickly with a metacentric height of 4.2feet at deep load and their six-inch guns were as wet as predicted.[5]
The cruisers were powered by two 4-cylinder triple-expansion steam engines, each driving one shaft, which produced a total of 23000ihp and gave a maximum speed of 23kn. The engines were powered by 20 Babcock & Wilcox water-tube boilers and six cylindrical boilers. The ships carried a maximum of 2150LT of coal[6] and an additional 600LT of fuel oil that was sprayed on the coal to increase its burn rate. At full capacity, they could steam for 8130nmi at a speed of .
The Duke of Edinburghs main armament consisted of six 45-calibre BL 9.2-inch Mk X guns in single-gun turrets, a much more powerful gun than used in the Devonshires.[7] The guns were distributed in two centreline turrets, one each fore and one aft of the superstructure, and four wing turrets disposed in the corners about the funnels. The centreline turrets could traverse a total of 285° while the wing turrets were limited to about 120° on the broadside due to muzzle blast. The gun had an elevation range of −5° to +15°. The 9.2inches shell weighed 380lb and was fired at a maximum muzzle velocity of 2778ft/s. This gave it a range of 15500yd at maximum elevation. The gun's rate of fire was about three rounds per minute[8] and the ships carried 100 rounds for each gun.[4]
Their secondary armament of ten 50-calibre BL 6-inch Mk XI guns was arranged in single embrasures. They were mounted amidships on the main deck and were only usable in calm weather. The guns could only traverse about 120° on the broadside. They initially had a maximum elevation of +13°, but this was later increased to +20°. This gave them a range of 14310yd at an elevation of +15° with their 1001NaN1 shell.[9] Each gun was provided with 150 rounds.[4]
Twenty Vickers quick-firing (QF) 3-pounder guns were fitted for defence against torpedo boats, six on turret roofs and fourteen in the superstructure, all on pivot mounts. These guns were too small to be useful against the torpedo boats before they got within torpedo range. They fired a 47mm shell that weighed 3.3lb and was fired at a maximum muzzle velocity of 2587ft/s. This gave it a range of 7550yd at an elevation of +20°.[10] 250 rounds were carried for each gun.[4]
The ships also mounted three submerged 18-inch torpedo tubes.[6] They carried a total of eighteen torpedoes in addition to the six 14inches torpedoes that could be used by the two 451NaN1 steam pinnaces.[11]
The Duke of Edinburgh-class ships had a 6inches waterline armour belt of Krupp cemented armour that covered 260feet of the hull amidships.[6] It covered the side of the ship up to the upper deck, a height of 14inchesft6inchesin (ftin) above the waterline and reached 4inchesft10inchesin (ftin) below it. Between the central citadel and the bow, the belt armour was 4inches thick and it extended to the stern with a thickness of 3inches. Transverse bulkheads six inches thick protected the citadel from raking fire.[12]
The faces of the gun turrets were 7.5 inches thick with 5.5inches sides and a 20NaN0 roof.[13] The barbettes were protected by six inches of armour as were the ammunition hoists, although the armour for those thinned to three inches between the armour belt. Two-inch armour screens separated each of the six-inch guns. The thickness of the lower deck was only 0.75inches except for a patch of 1.5inches armour over the steering gear and another 2inches thick over the engine cylinders.[6] The sides of the conning tower were 10inches thick.
The funnels proved to be too short in service and they were raised about 6feet four years after completion to keep the superstructure free of smoke in a following wind. In March 1916, both ships had all their six-inch guns removed, the embrasures plated over, and six of the guns were remounted on the upper deck. In May 1917, two more were added to Duke of Edinburgh on the forecastle.[14] The ship's foremast was converted to a tripod mast to support the weight of the fire-control director probably added in 1917.[15]
| Builder | Laid down[16] | Launched | Completed | Cost (including armament)[17] | ||
|---|---|---|---|---|---|---|
| align = center | Pembroke Dockyard | 11 Feb 1903 | 14 Jun 1904 | 20 Jan 1906 | £1,201,687 | |
| align = center | Thames Ironworks, Leamouth | 3 Jun 1903 | 8 Nov 1904 | 17 Mar 1906 | £1,193,414 | |
Duke of Edinburgh and Black Prince served in the Channel, Atlantic and Home Fleets before World War I. They were stationed in the Mediterranean when World War I began[12] and participated in the pursuit of the Goeben and Breslau as part of the 1st Cruiser Squadron, but was ordered not to engage. After the German ships reached Ottoman waters, the ships were sent to the Red Sea in mid-August to protect troop convoys arriving from India. While on escort duty they captured three German merchantmen.[18]
The two sisters rejoined the 1st Cruiser Squadron in December 1914, which had transferred to the Grand Fleet and participated in the Battle of Jutland in May 1916.[19] Black Prince became separated from the fleet when darkness fell and was sunk with all hands by German battleships later that night.[20] Duke of Edinburgh was not damaged during the battle and was the only ship of her squadron to survive.[19] After Jutland Duke of Edinburgh was ordered to reinforce the patrols north of the Shetland Islands against German blockade runners and commerce raiders.[21] She was eventually transferred to the Atlantic in August 1917 for convoy escort duties.[22] The ship was sold for scrap in 1920.[23]