Cyclone AX2000 explained

The Cyclone AX2000 is a British built three axis microlight, first flown in the 1990s. It seats two in side-by-side configuration.

Design and development

The AX2000 is a development of the earlier Cyclone AX3, a UK regulation compliant variant of the French Ultralair Premier AX3. This, in turn, was a three axis development of the US Chotia Weedhopper from the early 1980s.

The Cyclone AX2000 is an aluminium tube framed three axis microlight with flying surfaces covered with a polyester fabric with outer PVF lamination (URLAM). The whole aircraft is built around a long, high aluminium keel boom, which bears the engine, wings and empennage. The wing is a two spar structure, with surfaces formed by upper and lower battens rather than ribs. It carries conventional, full span, tapering ailerons but no flaps. The tailplane is mounted on the keel and has an anti-balance/trim tab on the starboard elevator. There is a small fixed fin below the keel but none above; the rudder is balanced and extends below the elevators, moving in a cut-out.

The short, deep fuselage is built around a wire braced tube beam. Lift and landing loads are taken by V-shaped, cross braced pairs of lift struts from the bottom of the fuselage to each wing, assisted by a centre line strut to the boom at the wing leading edge. The cockpit enclosure is non-structural, with forward opening doors to a pair of side-by-side seats. These are equipped with separate rudder pedals but the occupants share a central control column. The AX2000 has a tricycle undercarriage mounted close to the fuselage.

The engine is mounted, uncowled, ahead and above the wing leading edge, with the propeller shaft on the boom line. One of three engines may be fitted: a 48kW Rotax 582/48 or 38kW 503 2V, both upright twin cylinder two strokes, or the 45kW HKS 700E (either V3 or Beta variants), flat twin four stroke. Both Rotax engines drive propellers with ground adjustable pitch: the 582 has a three blade, composite propeller and the 503 a two blade wooden one.

As well the new engines, the AX2000 differs chiefly from the AX3 in having a completely double surface wing of reduced area and modified structure, a change of alloy for the main keel beam, a revised and lightened fuselage with new undercarriage, an increased fuel capacity and the addition of an elevator anti-balance trim tab.

The AX2000 is certificated as a glider tug, for gliders of class 1 and 2. A V-shaped forward tow line extension joins the main line to a pair of tug pillars attached to the rear spar on the under surfaces of the AX2000's wing.

Operational history

In mid-2011 there were 29 AX2000s on the UK civil aircraft register.

Variants

Cyclone AX-3:Production by Cyclone Airsports with either a Rotax 502 or Rotax 582 engine.
  • Pegasus AX2000:Improved variant produced by Pegasus Aircraft from 1996.

    This article is licensed under the GNU Free Documentation License. It uses material from the Wikipedia article "Cyclone AX2000".

    Except where otherwise indicated, Everything.Explained.Today is © Copyright 2009-2024, A B Cryer, All Rights Reserved. Cookie policy.