The Bartel BM 6 was a Polish biplane trainer fighter aircraft of 1930. It did not advance beyond the prototype stage.
The aircraft was designed by Ryszard Bartel in the Samolot factory in Poznań, as a trainer-fighter plane. The BM-6 prototype, designated BM 6a, was flown on 8 April 1930 in Poznań. Its advantage was an easy construction and maintenance, according to Bartel's design philosophy. A distinguishing feature of all Bartels was an upper wing of a shorter span, because lower and upper wing halves were interchangeable (i.e. the lower wingspan included the fuselage width). It first introduced a mixed construction to Bartel's designs.
After trials, the prototype was modified in July 1930. The prototype was later redesignated BM 6a/II after it was substantially modified. It offered quite good flight characteristics and was capable of aerobatic flight. It was demonstrated in a fighter-plane competition in Bucharest in 1930, along with the similar PZL P.1.
The second prototype BM 6b, with a Wright Whirlwind 220 hp radial engine, was ordered, but work upon it ceased with closure of the Samolot factory in mid-1930. The PWS works, which inherited many of Samolot's projects, did not continue the project, for it had its own similar design, the PWS-11.
Mixed construction biplane. Steel framed fuselage, rectangular in cross-section, canvas covered (engine and upper sections - aluminum covered). Rectangular two-spar wings with rounded ends, plywood and canvas covered. Upper wing span: 7.36 m, lower wing span: 8.10 m. Lower and upper wing halves were interchangeable. Single pilot, sitting in open cockpit, with a windshield. The V8 engine Hispano-Suiza 8Be was modified to lower power output (from 220 hp to 180 hp). Radiator below the fuselage. Fixed landing gear, with a rear skid. Two-blade wooden propeller of fixed pitch. Fuel tank in fuselage: 168 L capacity.
After state trials in 1931, the prototype was used in an advanced training school in Grudziądz, then in an aviation training center in Dęblin.